About 15 years of hands-on residential renovation work across walls, floors and wet areas. You deal directly with me, and every job starts with careful preparation, not a rush to the finished look.
LAYER — APPROACH
One of the most important lessons I’ve learnt over 15 years is that proper preparation often matters more than getting to a finished appearance quickly. A tile is only as good as the surface it’s laid on. If the wall is out of plumb or the floor isn’t flat, the problem shows up later as lippage, cracked grout or drummy tiles.
So I start by looking at what’s already there. I’ll explain what I believe needs to be done, why I’m recommending a particular approach, and what limitations may affect the work. That way you can make a decision with the full picture in front of you, whether it’s a full bathroom renovation, a kitchen splashback or a repair to a tired laundry floor.
LAYER — THE LEDGER
SURFACE
BED
MEMBRANE
SUBSTRATE
ASSESSMENT
SURFACE
Straight grout lines, even joints and tiles that sit flush with each other. I set out the layout before the first tile goes on, so cuts land where they make sense rather than in the middle of a wall.
BED
The right trowel notch and proper coverage under each tile help prevent hollow spots and cracking. I check the bed as I go instead of assuming it’s right.
MEMBRANE
In bathrooms and laundries, what happens under the tile decides how the room holds up over time. I take time with this stage, and where plumbing is involved it’s handled by an appropriately licensed plumber.
SUBSTRATE
Walls and floors are checked for level, movement and damage. Uneven surfaces are corrected before tiling, flooring or painting, because covering a problem doesn’t fix it.
ASSESSMENT
The right method, materials and scope depend on your property’s existing condition and what we find during an on-site assessment. That’s why I recommend a site visit before giving you a firm plan.
LAYER — TILING
Tiling is the core of my work in Melbourne homes: bathroom walls and floors, shower areas, kitchen splashbacks and laundry floors. Each job starts with checking the surface, planning the layout and preparing the substrate before any adhesive goes on.
More about wall and floor tiling →
Shown: a tile being positioned against a wall, used here for illustration.
LAYER — ROOMS
Shown: an unfinished interior with plasterboard, exposed plumbing manifolds and pipework, used here for illustration.
Where licensed plumbing, electrical or other specialist work is required, I coordinate it with appropriately licensed tradespeople. I don’t carry out that work myself.
From stripping old tiles back to the substrate through to new wall and floor tiling, I prepare and finish the room and organise the licensed trades it needs. It’s the work I’ve done most over the years.
Splashbacks, flooring, plastering and painting that bring a tired kitchen back into shape. Regulated work is coordinated with licensed specialists.
Practical, hard-wearing wet-area finishes for a room that gets plenty of use.
LAYER — FINISHING & OUTDOORS
Beyond tiling and room renovations, these are the residential renovations and home improvements I do around Melbourne. In every case, the scope depends on what the assessment shows.
Floor installation with the preparation it needs first: checking the subfloor, correcting uneven areas and planning transitions between rooms.
New plasterboard, repairs to damaged walls and ceilings, and setting that leaves a surface ready for paint.
Residential painting inside and out, with filling, sanding and priming done before the topcoat.
Residential decks built and repaired, with the frame and setout checked before boards go down.
Residential pergolas within my renovation scope. Where specialist structural or engineering input is needed, that is provided by the appropriate professionals.
Repairs, maintenance and smaller improvements, booked in during regular hours. I don’t offer emergency call-outs.
15
Approximately 15 years of hands-on residential renovation experience.
1,000+
More than 1,000 completed renovation and improvement projects.
Working in Australia since 2016, and in Melbourne since 2019.
Tools on a building site, shown for illustration.
LAYER — ABOUT IVAN BODNAR
I started learning renovation work alongside my father, then built my skills over many years working with tradespeople, renovation teams and as a subcontractor. Along the way I found I wanted to take responsibility for the whole job and deal with homeowners directly.
Today I work as an independent sole trader. When you get in touch, you’re talking to the person who will assess your home, organise the work and look after it on site. My aim is simple: help Melbourne homeowners maintain, renovate and improve their properties through reliable workmanship, practical advice and personal service.
LAYER — REQUEST A FREE QUOTE
The easiest way to reach me is a text message. Tell me what you’d like done and send a few photos or a short video: the whole room, a close-up of any damage, and the floor or wall surface. If it looks like a good fit, I’ll arrange a free site visit to inspect the property and talk through your options, followed by a free quote.
Text or call: 0413 142 055
Email: [email protected]
Hours: 9am–5pm, seven days
Area: Melbourne and surrounding suburbs
Quotes are based on the agreed scope and the conditions reasonably identifiable during inspection.
Leave your details, the service you need and your suburb or postcode. You’ll see a confirmation as soon as it’s sent.